Hi guys.
I am building a woodpecker tremolo and Q2 is a 2N2646. I ordered this part from Small Bear Electronics because that is the only place I could seem to find it. When it came time to solder it in it came to my attention that in order for the tab and the pins to match the printing the PCB, I would have to insert my 2N2646 in from the bottom of the PCB. Is this what I should be doing?
The "bottom view" shown there matches what is o the top side of the PCB, identifying the pin holes. If I insert from the top of the board as I would have expected it to go, the tab would be on the wrong side and Base 1 and Base 2 would be swapped.
Thanks in advance
I am building a woodpecker tremolo and Q2 is a 2N2646. I ordered this part from Small Bear Electronics because that is the only place I could seem to find it. When it came time to solder it in it came to my attention that in order for the tab and the pins to match the printing the PCB, I would have to insert my 2N2646 in from the bottom of the PCB. Is this what I should be doing?
The "bottom view" shown there matches what is o the top side of the PCB, identifying the pin holes. If I insert from the top of the board as I would have expected it to go, the tab would be on the wrong side and Base 1 and Base 2 would be swapped.
Thanks in advance