You did it all for the Mojo! Post your Mojo pictures!
- Thread starter ThePanda
- Start date
RetiredUnit1
Well-known member
My favorite 5E3, built around 15 years ago.... For those wondering, these were the original capacitors used in the Tweed Deluxe, well, except the .022 it was a more expensive upgrade to the one used in the 5e3.
RetiredUnit1
Well-known member
And this is Mojo, who would always go catatonic when the sun went down, lol.... He sees me but can't move. {RIP}
I wedged a metal can ua308 into this sunn life / rat clone. The metal can surely adds more mojo than a dip8 lm308 would.
In this pine esquire I made with a single p90, I went with original esquire wiring, and I used some mustard caps I found on eBay. Excuse the pcb pin tone pot, a 250k reverse audio CTS pot proved difficult to find at the time (left handed).
That’s all I can think of at the moment
In this pine esquire I made with a single p90, I went with original esquire wiring, and I used some mustard caps I found on eBay. Excuse the pcb pin tone pot, a 250k reverse audio CTS pot proved difficult to find at the time (left handed).
That’s all I can think of at the moment
enrosenzweig
Well-known member
It looks like the lamp is sitting on some mojo tooMy attempt at DIY 'mood' lighting:
I think it brings a certain type of mojo to the room.
*Maybe don't stick your hand in there though- I built it when I was 19
dawson
Well-known member
Good eyeball, @enrosenzweig!
I'm super lucky that piano found me- more Rhodes pictures and info' in this linked thread.
I'm super lucky that piano found me- more Rhodes pictures and info' in this linked thread.
enrosenzweig
Well-known member
Wow, I had not seen that thread! Great stuff!
Passinwind
Well-known member
Lots of superfluous fluff, AKA Mojo, in this tube bass preamp build:
And that's before I installed the NOS 6SL7 and 6SN7s, or tricked out the wiring harness.
The Jensen output at top center is a 4:1 stepdown, which allows running the output quite hot, something like 28V RMS max. MEC pots, PRP resistors, Solen and MuiltiCap polypro caps...total overkill, just because I like how they look.
But when I finally get back to my latest tube amp build I'll be going next gen on this front panel concept:
Handmade purpleheart knobs on a laser etched curly maple fascia panel, because Mojo never sleeps. That's just a proof of concept mockup, I'm sure we can go more over the top!
Last edited:
jimilee
Well-known member
Bricksnbeatles
Member known well
Not a mojo picture, but a mojo question nonetheless. Is Fuzzcases the only place to get MKII, Supa Fuzz, and FF style cast aluminum enclosures these days, or there any other notable vendors who perhaps sacrifice some accuracy for the sake of cost, or are stateside at the very least?
Fuzzcases.com for reference
Fuzzcases.com for reference
cliffs_trip
Well-known member
I made a black ash clone with the mojo caps and some vintage 2N3903s. I like the stripes!
steviejr92
Authorized Vendor
A Fuzz Face With some Mojo Parts! Uses PNP GE Transistors with the circuit flipped upside down to compensate.
drgonzo1969
Well-known member
steviejr92
Authorized Vendor
@drgonzo1969 Thats one badass guitar!