Johnnyorange500
Active member
Hi,
I stupidly counted the measurements wrong for my tone bender mki strip-board. And cut it by x8 instead of x9. And followed this layout. So the ailments are going to be a little off. I’ve tried to compensate for this..I’ve not committed to soldering it yet., am I best recutting another stripboard. Or is there a way around this.
Cheers
Johnny
P
I stupidly counted the measurements wrong for my tone bender mki strip-board. And cut it by x8 instead of x9. And followed this layout. So the ailments are going to be a little off. I’ve tried to compensate for this..I’ve not committed to soldering it yet., am I best recutting another stripboard. Or is there a way around this.
Cheers
Johnny
P
Last edited: