mkstewartesq
Well-known member
Any update as to how this one is coming along/any rough idea as to an ETA? This is definitely the project I am most looking forward to.
Mike
What's on the workbench?
- Thread starter PedalPCB
- Start date
Any update as to how this one is coming along/any rough idea as to an ETA? This is definitely the project I am most looking forward to.
Mike
Robert
Reverse Engineer
It's traced and the layout is started.
Moving 4 footswitches to the side to get it in a 125B? Just wedge it real tight between 2 other pedals and kick the corresponding corner of your pedalboard. Soft actuators or steel toes required.
giovanni
Well-known member
That looks cool. I love that it has the envelope filter. Is it based on PLL?
Feral Feline
Well-known member
Last edited:
jimilee
Well-known member
Well, there you go. Thank you.
Last edited:
EZS
Well-known member
Not really on the bench, but started tracking after a woodchipper/finger/infection injury. Thanking guardian angles.
Shown are a few pedal pcb dirt boxs with a somewhat sentimental head. Its had 25years of every mod in the books plus some. Swiss Cheese chassis. Restored back into an early SLP spec. Early Megadeath/Lee Hackson amp in 86. Back when Ebay was still a find (99-00?) money orders etc.. Did not work and covered in black epoxy goo and cold solder joints everywhere. Including Archer (radio shack) relays and transformer, lights, for channel switching. I contacted Lee and asked him if he could help guide me into to restoring it. His blunt answer was no, "buy my video." So I gutted it and cursed his name for good.
Shown are a few pedal pcb dirt boxs with a somewhat sentimental head. Its had 25years of every mod in the books plus some. Swiss Cheese chassis. Restored back into an early SLP spec. Early Megadeath/Lee Hackson amp in 86. Back when Ebay was still a find (99-00?) money orders etc.. Did not work and covered in black epoxy goo and cold solder joints everywhere. Including Archer (radio shack) relays and transformer, lights, for channel switching. I contacted Lee and asked him if he could help guide me into to restoring it. His blunt answer was no, "buy my video." So I gutted it and cursed his name for good.
Last edited:
Feral Feline
Well-known member
"Lee" who?
Seriously. Who?
Seriously. Who?
EZS
Well-known member
Lee Jackson.
ICTRock
Well-known member
I got on the kick of collecting some red witch stuff ... the seven sisters series is a trip down clone memory lane ... the boost is a master volume SHO, the compressor is a rothwell love squeeze, the overdrive is YATS, the distortion is a BoR, the fuzz is a Si FF, the tremolo is an EA, and I haven't scooped up a delay yet because I'm waiting for one with box and paperwork that isn't $200 for what is probably a deep blue delay or similar.
Aquaticwombat
Member
Can we name it the ocean gate?
owlexifry
Well-known member
Paradox916
Well-known member
Woah is that a 1590a with no side jacks? What is the witchcraft?
Robert
Reverse Engineer
It's a tone generator so it only has a single top-mounted output jack... but it does have an internal 9V battery.
There's a pic of the previous revision (before switching to a sub-mini power switch) here:
Bench utilities
Where can I find these? I don't recall the specific vendor, but g00gle "pogo pin test clamp" and you'll find joy. (y)
forum.pedalpcb.com
Similar threads
