pingpongcomputer
Well-known member
I deleted the guesswork drill guide I made for the Muffinator. I made everything fit, but several of my "measurements" were off. Figured it was better to take down the post and not lead others astray.
Missing Build Docs / Schematics
- Thread starter Robert
- Start date
Robert
Reverse Engineer
Your template looked correct to me.
Keep in mind the LED almost never aligns with the pads on the PCB with the projects here. That would require either some really wonky LED placement, or severely oversized PCBs just for the sake of LED alignment.
It also allows for the use of the big bulky metal LED bezels that would otherwise short against the back of the PCB.
mralanmorgan
Member
Is this a good template for the Muffinator then?
mralanmorgan
Member
It looked good so I used it. It worked perfectly. I usually have a hard time with toggle switches lining up right, but this was spot on.
Robert
Reverse Engineer
mralanmorgan
Member
No worries! It came together nicely. Do you have any recommendations for different diodes?Sorry, just saw this.
Yep, that's the one, but you know that by now.
zeropluszero
Well-known member
Lycan Overdrive build docs?
temol
Well-known member
bump...Any chance for the Sandblaster Fuzz schematic?
Scabbard Overdrive would be nice too
zeropluszero
Well-known member
I'd settle for a yes / no I can buy all its parts from tayda
zeropluszero
Well-known member
SCABBARDbump...
Scabbard Overdrive would be nice too
---------------------
4 100R
1 1K
2 2K2
1 4K7
3 10K
1 20K
3 47K
3 1M
3 1n
1 3n3
2 10n
3 47n
3 1u MLCC
* Filtering/decoupling, use MLCC
11uF E
4 4u7
2 100u
2 D9B
1 5817
4 A100K
2 OP07
1 8.2uH
* https://www.taydaelectronics.com/8-2uh-inductor-ec24.html
1 ON/ON
I have the drill coordinates for tayda if you want them.
Robert
Reverse Engineer
I'd settle for a yes / no I can buy all its parts from tayda
I'm pretty sure you can.
Robert
Reverse Engineer
Knock, knock...
Any chance for the Sandblaster Fuzz schematic?
temol
Well-known member
Thanks for your offer, it won't be necessary. I already have everything I need.
I'd like those coords, if you please. Scabbard is a definite future build from me! I'd love to see the schem for it too whenever that drops.
zeropluszero
Well-known member
Obviously check the diameter of your holes, but my PCB has dropped right into this.
Thank you very much, I appreciate it. I'd like to get one printed and drilled when I get around to that project so this is very helpful.Scabbard (rev 1?)
Obviously check the diameter of your holes, but my PCB has dropped right into this.