Passinwind

I’ve been doing HPFs in most of my DIY bass amps and preamps for many years, usually with a bit steeper slope than Josh uses though...

Yeah uprights have to battle a lot of sub. Hence the broughton high passes everywhere

With a piezo lower Z loading tends to cut the lowest bass octave, which is not necessarily a bad thing for AUB. Especially with my...

They aren't cheap that's for sure. I always see 10Meg quoted for uprights but I'd bet that is overkill.

The last acoustic upright pedal I did for a friend which had a Fishman BP100 pickup system ended up sounding best to us at ~700k, which...

Not yet, but I’d probably use one of my higher impedance open source preamp pedals as a front end, or maybe the 10meg Creation Labs...

Hm, quite the opposite of what I was thinking but it makes sense. Lo z lowers the q of the pickup. Granted that can come with its own...

My new DIY tube bass amp is actually getting a switch like that this week. Since I only play active basses I started with a 100k input...

Like medium to lo-z inpits? It's an interesting concept if so. Probably enhances the character of each instrument. It's interesting...

Yep, killing/neutering the pickups natural resonant peak with a tailored Z load so you can impose a variable one with a resonat LPF, for...

Yes, that works...;)

I perused around the DaisySeed sub forum and read there is now a DaisySeed 3. I ordered a few. I’ll try swapping it out to see if it...

I haven’t seen a build report for this PCB yet. I dig it- a digital pedal platform with a standard 3-knob layout and true bypass. This...

It's essentially a pretty basic Baxandall circuit, here's what's going on on both sides of the feedback resistor in that stage...

Waveform correlation bewtween transient sine wave modeling and my oscilloscope was pretty good, next up is recording some clean guitar...