DGWVI
Well-known member
- Build Rating
Fairly straightforward Rat clone. My only changes were replacing the 560r/4.7u with 220r/47u(Juggernaut values), and adding a 470r resistor between lug 1 of the distortion pot and the board
UD1408A for the chip, and D9K for the clippers
Gets a lot fuzzier than a traditional Rat, and pairs wonderfully with them, either pre or post
Top-jacked Gorva M45, Taiway mini 3pdt, Lumberg jacks. This was the easiest of the recent mini builds I've done, with M45 offering a decent bit of room over either the the 1590A or Bud MiniBoxes
Here's some sounds, enjoy the fuzzy fizz
I A/B and stack it with a stock Rat2 toward the end
UD1408A for the chip, and D9K for the clippers
Gets a lot fuzzier than a traditional Rat, and pairs wonderfully with them, either pre or post
Top-jacked Gorva M45, Taiway mini 3pdt, Lumberg jacks. This was the easiest of the recent mini builds I've done, with M45 offering a decent bit of room over either the the 1590A or Bud MiniBoxes
Here's some sounds, enjoy the fuzzy fizz
I A/B and stack it with a stock Rat2 toward the end
