Electrovibe capacitors

[tonycombs]

Did I make a BIG mistake by putting in 16 volt caps in my Electrovibe?

 

[Nostradoomus]

you sure did!

 

[Spiff4565]

I'm stocking up on parts for this build. Going with Nichicon and Panasonic
50V electrolytics.

 

[tonycombs]

I thank you for your reply…guess I need to pull and replace them. I’m kinda new to the process and ordered the parts quite a while ago…I appreciate you helping me in this learning process…

 

[Big Monk]

I thank you for your reply…guess I need to pull and replace them. I’m kinda new to the process and ordered the parts quite a while ago…I appreciate you helping me in this learning process…

After a while you start to get a feel for what is safe from premature failure and letting out the magic smoke.

Technically you should be good with leaving all the caps in the phaser section at 16v.

Power supply caps PRE charge pump should be good at 16v but anything POST charge pump should be rated at least 25v, with 35v preferred.

You have to think about what voltages are “hitting” those caps directly.

For the phaser stages, you might have 12v at the bias resistors of the darlingtons but those caps in the phaser stream are not getting that much voltage and 16v should be fine.

In reality, the only caps you should have to change are those “seeing” 18v directly.

 

[tonycombs]

That is good news…I will get on that…many thanks. My Semi Sweet Distortion went so well, I was bound to hit a snag sometime…

 

[tonycombs]

I can see why you are a Well Known Member…being more of a musician than a technician, and being more comfortable reading a score than a schematic, am I correct that the Caps in question are C 11, 19, 27, and maybe 22? Thank you again Big Monk

 

[Big Monk]

I can see why you are a Well Known Member…being more of a musician than a technician, and being more comfortable reading a score than a schematic, am I correct that the Caps in question are C 11, 19, 27, and maybe 22? Thank you again Big Monk

I’m not sure. I’d have to look at the schematic.

 

[Big Monk]

To be conservative I’d say C17, C11, C22.

Also make sure you used a 12v regulator. I know the docs call for a 15v the 18v tap actually delivers a little less than 18v and it’s too close to the regulator threshold and sometimes does not regulate.

The forum established pretty early on that something like a 78L12 is perfectly suitable as those stages really don’t need to be running at 15v.

 

[Guardians of the analog]

I can see why you are a Well Known Member

Monk is the expert on vibe...making it so the vibe is off

 

[tonycombs]

Thanks everybody! So great to have resource like this with so many knowledgeable people to get advice from.

 

[Guardians of the analog]

Thanks everybody! So great to have resource like this with so many knowledgeable people to get advice from.

 

[spi]

I can see why you are a Well Known Member…

They'll give anyone a well known member tag here.
<- ???

 

[Big Monk]

They'll give anyone a well known member tag here.
<- ???

Exactly. I didn’t do any special to get it.