Search results

First of all, mine ain't a Rat, it's a Snitch!! Holy crap I love the sound of this pedal. I used an Op07 I because I didn't have any of the 358s on hand and my experience has been, you either pay much more or get duds if you go cheap. This IC is readily available and sounds great. If you...

Hi all, just finished the Aft preamp and I used a 2N2222A since I didn't have an Oc139. Hfe was 275. It's super noisy, almost microphonic and seems like there's almost a delay before the sound kicks in. Just a weird vibe. The OC datasheet I looked at had the Hfe about 33. So my dumb fault...

Sorry to bump this old thread, but it kind of answers the question I had (how to build a caverns type pedal). The only other question I have is this. How hard would it be to add a blend knob to this, like the caverns has. If it possible to add on this dual pedal setup? Thanks all

If I want to add a momentary switch to give infinite delay on seabed pcb. I've seen to add one leg to leg 3 of feedback and the other to leg 3 of delay. Is it that simple?

Yeah, I thought of that, but the sound just gets so heavy when I roll back the tone (which increases the volume) that I think there has to be something up with the circuit (likely my error), but I just can't pin it down.

Howdy all, I just finished up the Tweed 59. When engaged there's a bit of a volume drop, UNLESS I turn the tone all the way to the left. Then, it really cuts the high frequencies, but also boosts the volume. I reflowed everything. I have no bridge joints and I'm at a loss as to why this would be...

While it's pretty easy to figure out if you can read a schematic, thought I'd suggest adding labels to pots on boards where all pots are the same value. Not everyone reads schematics, so for labeling purposes, it could help them (off the top of my head I'm thinking things like the Byrdhouse...

I Yeah, I've done all the usual troubleshooting. I may need to go back to see if I have mixed up some resistor values but not sure where to start there

I definitely don't. I reflowed all the joints

Here's a gutshot

Hi all, Not sure if this is a troubleshooting or mod question, but I think it's troubleshooting. Anytime I build a pedal, I set all the knobs to noon and see how close I am to volume without the pedal active. To get to unity volume I almost have to crank the volume the whole way up. That seems...

Here's a demo:

Can you share the svg please

How could I forget the gutshot!!!

This pedal sounds amazing. One of the things I appreciate about pedal pcb is they tell you what the circuit is based on, so you can get an idea of the sound. I saw this was based on Lumpy's Tone Shop Lemon Drop, and immediately Pink Lemonade popped into my head for a name. I found the pink...

OK, I'm an idiot. Thank you so much!!!

Hello all, Just built the lemonade pedal and it sounds absolutely killer. I'm not getting a very wide range with the filter knob. Looking at the schematic there's a 1m resistor going in and a 4u7 and 4n7 capacitor in the other side. If I dropped the 1m to 500k, would that increase my sweep...

I have a few pcbs from another manufacturer that has 4 knobs, so I ordered a couple of the 4 hole drilled enclosures from Tayda. But the boards I have mount the knobs differently so they would be too close to the input jacks if I use these enclosures. Anyway, waste not want not, I'll build a few...

No, text was laser, and the Satyr outline was masking tape over the enclosure, then lasered the cutout, and sprayed with matte laquer