Angry Charles presence control mod

[harrisxr650]

Hi everyone, new to the forum,

Just ordered an Angry Charles pcb and i was wondering if anyone has done a presence pot mod and which resistor is to be replaced with a pot.

I know i might not need it but i would like to have it as an extra function to control tone,

if it makes an difference the chain order will be wah>AMZ clean booster>fuzzes>klon type od>suhr riot clone>Angry Charles>TS808 clone>box of rock clone.

the bor is 90% always on at very low or 0 gain settings.

Thanks

 

[Pedalnoobster]

is this what you’re kinda referencing? I have the same question, I’m guessing if u copy this presence control from the MI audio schematic into the A C it should get u close. I’m guessing putting it in after the EQ section and b4 the output Vol.