SOLVED Comprehensive drive no sound I have a few questions?

[PAGOON]

I just put together the comprehensive drive and and when I went to use it there’s no sound but it has sound when the pedal is off. Here’s the question I noticed after I had plugged in this pedal that I had the 4558 ic upside down o was wondering if I may have burned out some component. Also I didn’t have a 1k05 resistor so I just used a 1k I doubt that makes a difference hahaha… and also I double checked and went through and resoldered all the sketchy possible cold weld solders… tomorrow I will double check the resistors but I’m pret sure they are all correct here’s som pictures …
Any insights greatly appreciated

 

[carlinb17]

you definitely could have cooked the ic. I would also recommend cleaning off the flux, reflowing, and then cleaning again. Your led is also on the wrong side of the board.

 

[PAGOON]

Yeah the led is just in there for a test not solder.. I replace the ic and nothing k was wondering if the trans the 2n5088 may have cooked Im going to poke around with the dvm tomorrow

 

[carlinb17]

Can you take a clear picture of the power plug? Does the led turn on when you engage the switch? How are you powering the pedal

 

[PAGOON]

Yeah the led turns on the power plugs wired right… I did have trouble with one of the resistors… I put all of the resistors in at once and when I flipped the pcb over r21 slid out a half inch and I soldered it bent and I slowly heated each side and slid the resistor down flush I’m thinking I may have overheated the rings where the resistor slides through but they looked ok when I soldered it in … I use a hiree and I also have a 9volt external plug o uses for diag

 

[fig]

R1 appears to be a 51K instead of a 51R?

 

[PAGOON]

Yup I just figured it out!!! I labeled my bag wrong … damn this Is not the first time this has happened! Thanks for all the insights …