Connecting the LMS LED v2 Daughter Board to the Taqueria Board

[KAMERTAJ]

Hi,

I got the 3PDT LED v2 board from LMS but I'm not clear on connecting it to the Taqueria board.

The Taqueria PCB has "In Gnd SW Out" at the bottom.

The LMS board has:
J = Input Jack Tip
I = Circuit In
V+ = Positive Voltage - there's 2!
G = Ground
O = Circuit Output
OJ = Output Jack Tip
GND = Ground

I guess the only one I don't see is SW. I was thinking of using a ribbon cable for a quick connection but the pads don't seem to match up with theTaqueria board.. This is my first pedal build so I'm new to this & probably missing the obvious. If SW is used for an LED, I think I can use the other contacts on the LMS board for the LED. Does anybody know what the correct pad is for me to connect SW to?

Thanks

 

[KAMERTAJ]

Hi All,

Love My Switches wasn't able to provide me with any information on their board. If anybody can steer me in the right direction, I'd really appreciate it. This is my first pedal project & I'd hate to screw it up.

Thanks Very Much,
Bruce

 

[pbrommer]

SW is using a pole to connect K to ground.

If you’re going to use the CLR and LED on the LMS board, you’ll need to connect A (above the I/G/S/O to V+ on the LMS board. That will bring V+ to the 3PdT board and then should let you use the CLR/LED on the LMs board. There won’t be a connection from SW.

If you can check continuity from the V+ on the switch board to the Anode (Circle pad) on the switch board and it connects (beeps), then you should be good to go. Worst that happens is that the LED doesn’t work.

I’m 98% sure this is correct, but if there’s another set of eyes here to check me, that is golden.

 

[KAMERTAJ]

Hi pbrommer,

Excellent! Thanks very much!

Bruce