D3lay not affected

[uptown_sniffer]

When playing guitar through the pedal the mix and level knobs affect the signal, but the others do not. The non-audible pots measurements change when they are rotated. There is no audible oscillation. The FV-1 seems to have normal voltages. Is there a signal path I can probe to solve this wacky mystery? Any perspective is appreciated. I am aware that I need to clean up the soldering and leads.

 

[swelchy]

is your 15pf a tantalum/polarized?.. better pics from other angles and the back of your board will be required for further advice.

 

[Locrian99]

is your 15pf a tantalum/polarized?.. better pics from other angles and the back of your board will be required for further advice.

I think thats an mlcc not a tant.

 

[swelchy]

I think thats an mlcc not a tant.

likely but suspect since he has a clock issue

 

[phi1]

I would use an audio probe to check for signal at the fav-1 input pin (pin1, top left) and output (28, top right).

 

[uptown_sniffer]

I would use an audio probe to check for signal at the fav-1 input pin (pin1, top left) and output (28, top right).

I get clean guitar at pins 1 and 2. Nothing audible after that.

 

[uptown_sniffer]

likely but suspect since he has a clock issue

How would I go about testing this?

 

[uptown_sniffer]

is your 15pf a tantalum/polarized?.. better pics from other angles and the back of your board will be required for further advice.

 

[phi1]

You can also access the programs built into the FV-1 by grounding pin13. you can do this by slidering a wire onto whichever side of R5 connects to pin13 and grounding that wire.

This would get you the patches 0, 1, and 2 listed here (depending on toggle switch position).

 

[swelchy]

your aware that all of the pcb's here are designed to have pcb mounted pots right?