Is this a decent power jack for the Arachnid? I want something quality but have seen comments on metal jacks shorting to the metal case with the outside metal barrel.
https://www.taydaelectronics.com/1614-19-lumberg-dc-power-socket.html
Data sheet
If this would be a problem any suggestions for a jack that mounts from the inside out with the nut like the metal one above?
I want to be able to test the PCB outside the enclosure and then install into the case.
The plastic ones seem cheap and the nut goes on the inside so it needs wired after the PCB is installed.
Plastic 2.1mm power jack
Thx!
https://www.taydaelectronics.com/1614-19-lumberg-dc-power-socket.html
Data sheet
If this would be a problem any suggestions for a jack that mounts from the inside out with the nut like the metal one above?
I want to be able to test the PCB outside the enclosure and then install into the case.
The plastic ones seem cheap and the nut goes on the inside so it needs wired after the PCB is installed.
Plastic 2.1mm power jack
Thx!