giovanni
Well-known member
I bought some of these foot switches a while ago and never used them, until I noticed this board. Does this simply require omitting the on board LED? Or does it need to be shorted or something?
-
BLACK FRIDAY SALE!
20% off all PCBs - No coupon code required - Valid through 12/01/2024
Components and sale items excluded
Illuminated 3PDT breakout board question
- Thread starter giovanni
- Start date
Paradox916
Well-known member
It’s been a minute since I used one but I had adjusted the resistor to taste. And jumpered the LED pads on the PCB I believe, Is this the technically correct way? Not 
on that. I don’t remember how I came to that conclusion.
if I remember correctly Red required a lower value resistor to achieve my desired brightness.
on that. I don’t remember how I came to that conclusion. if I remember correctly Red required a lower value resistor to achieve my desired brightness.
jeffwhitfield
Well-known member
Yeah, if you’re using an illuminated switch then, yes, you have to jumper the built-in LED spot on the PCB.
Similar threads
