Intelligent Relay Bypass Module

[Manuel]

Hi

Just wanted to know how/if the various modes of the "Intelligent Relay Bypass Module" could work simultaneously? Say as an example that I would like to have two modules in a pedal housing two overdrive circuits where circuit no one is off when powering up and the other is on when powering up. However I would also, at the same time, like to connect the two modules utilising the "channel switching mode" option so that only one at a time can be on. And finally I would like both modules to be in the "Instant Momentary mode" so that I can controll it via the ctrl out of my boss Ms3. This would meen using three of the modules modes at trhe same time. Would this work?

Best Regards
Manuel

 

[Robert]

At the moment no, it only operates in one mode at a time.

 

[benny_profane]

At the moment no, it only operates in one mode at a time.

Quick question: have the MCUs changed at all between the first version and the one with the control pads?

 

[Robert]

The code has changed but they should be interchangeable (sacrificing the CTRL function).

The part number changes depending on what is available (and current pricing). You may see an ATTINY13, ATTINY25, or ATTINY85 depending on availability.

 

[benny_profane]

The code has changed but they should be interchangeable (sacrificing the CTRL function).

The part number changes depending on what is available (and current pricing). You may see an ATTINY13, ATTINY25, or ATTINY85 depending on availability.

So there's no way to know which has the CTRL function without testing?

 

[Robert]

Hmmm..... Not really.

If it's ATTINY85 it's almost definitely going to be the earlier version before the CTRL function was added. ATTINY25 is most likely pre-CTRL function as well, but there might be a few floating around from the first batch.

ATTINY13 could be either.