DGWVI
Well-known member
- Build Rating
- 5.00 star(s)
A Gas Tank (Brown Dog clone) into a JMK Paralyzer, with a Junk Trunk (Agent 00Funk clones) in each loop. There's and FX loop between the Gas Tank and Paralyzer, with another between the send of the Paralyzer and second Junk Trunk.
No mods done to the Gas Tank, so it's just that classic gated, clean-blendable fuzz we all know and love.
Mods to the Junk Trunks include:
I also used NE5517s in place of the LM13700s, but I don't hear a difference in this circuit.
You'll notice two jacks adjacent to the 9v jack. These were meant to be CV outs from the envelope detector but, they don't seem to work when it's boxed. I'm not too fussed about them, but I will revisit and get them working eventually
My nerves are acting up today, so haven't done a comprehensive Demo, but here's a couple to show it's working
This one's just showing off the range of the frequency cap selector on a single Junk Trunk
This one shows off a bit of the parallel action
I HIGHLY recommend the Junk Trunk to any fans of envelope filters. Has a ridiculous range and is full of a ton of amazing tones. Does funk to synth without breaking a sweat
No mods done to the Gas Tank, so it's just that classic gated, clean-blendable fuzz we all know and love.
Mods to the Junk Trunks include:
- C2 & C3 replaced with a 2p6t with 1n, 4.7n, 10n, 22n, 47n, and 100n caps selectable. This takes the filter from shrill to thumpy
- C6 has been replaced with a toggle to select the stock 4.7u or a 1u for quicker decay
- I used Orange LEDs for the peak detector because of their slightly lower vf compared to the Yellows the build docs calls for. This allows a bit more control voltage into the filters from the envelope section
I also used NE5517s in place of the LM13700s, but I don't hear a difference in this circuit.
You'll notice two jacks adjacent to the 9v jack. These were meant to be CV outs from the envelope detector but, they don't seem to work when it's boxed. I'm not too fussed about them, but I will revisit and get them working eventually
My nerves are acting up today, so haven't done a comprehensive Demo, but here's a couple to show it's working
This one's just showing off the range of the frequency cap selector on a single Junk Trunk
This one shows off a bit of the parallel action
I HIGHLY recommend the Junk Trunk to any fans of envelope filters. Has a ridiculous range and is full of a ton of amazing tones. Does funk to synth without breaking a sweat
Last edited: