Low tide

[Phillipk]

Hi
First post here a beginner started late in life I built the low tide a while back and it sort of worked. However now I get nothing. I have read all of the problem posts and am working through those but while reading post by Dsonthebeat 24 nov 2023 I noted in his photos that his randomiser supplied with the board is a tiny25v, mine is a tiny13a. I have checked and there appears to be quite a difference. Have I got the correct one?
Thanks

 

[jimilee]

@PedalPCB

 

[Locrian99]

Hi
First post here a beginner started late in life I built the low tide a while back and it sort of worked. However now I get nothing. I have read all of the problem posts and am working through those but while reading post by Dsonthebeat 24 nov 2023 I noted in his photos that his randomiser supplied with the board is a tiny25v, mine is a tiny13a. I have checked and there appears to be quite a difference. Have I got the correct one?
Thanks

The one i built about a year ago came with the 13a and worked fine. Verified a pic

 

[Phillipk]

Thanks for that! I’m a bit annoyed because it worked when I built it and needed fine tuning but now I’m getting nothing Just noted funny that I’ve got a slightly melted cap in that position! This was a tight build!

 

[Erik S]

Do you get sound through when the pedal is bypassed?

Does the LED turn on?

I’d look for something that went wrong with a wired connection first.

Post some more pictures of the whole situation too.

 

[Phillipk]

Yep sound on bypass and led on. Ill start signal chase and wiring check. Will post if any news. Thanks for that

 

[Robert]

You could have an ATTINY13, 25, or 85, depending on what was/is available at the time.

 

[Locrian99]

Thanks for that! I’m a bit annoyed because it worked when I built it and needed fine tuning but now I’m getting nothing Just noted funny that I’ve got a slightly melted cap in that position! This was a tight build!

Yea i think i mustve done that with the dc jack oops