Magnetron Delay troubleshoot

[u439857293874]

This was one of my first builds I'm trying to get working. Just redid the wiring but I'm not getting the effect. I'm going though the schematics but I'm a little unsure how to read it.

Should I have sound on both sides of R2 and R3?
R10 I'm not getting anything at all.

On the PT2399 chip I can hear the delay happening on one of the pins and on R25/R26 but R11 and R14 sound like the bypassed signal. Any help would be greatly appreciated, thanks!

 

[Locrian99]

I was getting the effected audio on only one side of r13 so i ran a jumper from r12 to r13 and now i can hear the effect on the output. It doesn't sound great and I'm only getting audio on pin 3 of the feedback pot. At least we're getting closer! Will try some more after work. I'm on the old version btw. Build doc says 2020.

Well r12/13 aren’t in series by any means. But if doing so gives you signal I suspect you’ve got a cold joint in thag area. I would reflow all the joints in that area of the schematic. And double check component values. Also the whole right side of the pt2399 should be around 2.5v…