chancefrank
New member
Can we get the build docs for the Acrobat Parametric Distortion? I keep ordering the wrong switch and the wrong jacks. I’ve had the pcb for months but can’t finish the build.
Missing Build Docs / Schematics
- Thread starter Robert
- Start date
giovanni
Well-known member
I did? I must be having a brain
Fontelroy
Active member
I've been obsessed with harmonic trem lately, particularly in stereo and was curious if the stereo pendulum two harmonic trems are opposites of each other in terms of the low pass and high pass filters for the left out being flipped in phase for the right out? It looks like it still doesn't have build docs or a schematic so I can't really tell.
giovanni
Well-known member
I literally did not see that until now... gotta go back to bed.I did? I must be having a brain
Stickman393
Well-known member
Quick Q regarding the tone generator:
I'd like to do some knobby knob labels on my Toner Pill. I imagine the DPDT is power, A100k Volume, and...B1M Freq?
I'd like to do some knobby knob labels on my Toner Pill. I imagine the DPDT is power, A100k Volume, and...B1M Freq?
foaminginfection
Member
When we getting the build docs for the Tone Generator? Been months, yo. I need a schematic.
Fet_street
New member
Fuzzy fox been missing docs for a long time
Any update for the ADHD build docs?
I've recently built a Ge version by simply using the PCB layout values. Piece of cake.
Now I ordered another set of PCB's and want to build out a V1.4 ( Updated to include all versions (V1.x, V2, and Ge)
and I'm hoping to have build docs soon rather than trace out the PCB with V1.4 schematics.
Additionally, the drill guide for the original ADHD and ADHD V2 aren't quite right since the switch shaft is not on the horizontal axis with the tone pot shaft.
Thanks
Cybercow
Well-known member
Lytt Effects
Active member
Also looking for ADHD docs. The values on the PCB are fine for most builds, but building a specific iteration for this particular board would be nice, especially since I’m looking to do multiple different versions and have a few boards sitting and waiting.
Robert
Reverse Engineer
This isn't the complete doc with drill template/wiring diagram/etc, but has the PCB and schematic for the purpose of translating values from another version.
sticky1138
Well-known member
Would love to see a drill template for the 4-Tap. Mine is just sitting on the shelf naked, staring at my unpowered mini-board with sad eyes.
I made one... home spacing need an update to correct spec, but height is perfect
sticky1138
Well-known member
This one ? Updated for 21.59mm spacing
Lytt Effects
Active member
Got it, thank you!
Found a couple of sites that have the component differences for at least V1.1-4, so that’s a start. Should be able to sort it out.