PCB damage

[chongmagic]

I have this piece of solder mask missing on a PCB I recieved today.

New photo · Monday, Nov 18, 2019 📸

Tap to view!

photos.app.goo.gl

Will it cause any issues?

 

[Nostradoomus]

You will have to jumper the traces if it has cut any of them. I’d also put some liquid electrical tape over that sucker after cleaning it up a bit. I’m sure you’ll get a replacement though, unless you want to just hack it haha

 

[chongmagic]

This is my second Duo Phase with some damage, I think I will try my luck with it.

 

[Nostradoomus]

That sucks! Did they get damaged in transit?

 

[chongmagic]

Has to be since a big board and all.

 

[Robert]

That's a little more serious than some solder mask missing, although it does appear to be in the ground plane....

That's a big board to take chances with.... Sending you a PM.

 

[Betty Wont]

I recently did a batch of 5 duo phase and 2 of the boards had the same issue. One of them I found no continuity issues, and the other had no continuity on one of the led switch traces. I hacked that one and it works fine.

 

[Robert]

I recently did a batch of 5 duo phase and 2 of the boards had the same issue.

That's no good. I'll check the bin today and make sure none of them have this issue.

Shoot me a PM if you want replacements.

 

[Dali]

My Duo-Phase PCB sent October 12 is ok.

 

[Chuck D. Bones]

Mine was perfect, received 9/18.