Stickman393
Well-known member
Got this one soldered and built...haven't done a plug in test yet...its like 3am here. Final pics to come...anybody know what the trimpot does? Or how to set it?
I'm a much bigger fan of the whole "set to measurement" than "set by ear" thing. I do the same thing with cooking...I wanna measure out every ingredient. Drives stick lady crazy.
As difficult as it was to avoid the obvious joke, I kinda like this more. Just binged the series, rather liked it, so why not?
Still...Im having some difficulties with the transfers and etching. Alignment is difficult to get right...I always seem to get it skewed by a degree or so. My little 30 watt power supply doesn't quite have the oomph to get it done in a reasonable amount of time either.
Thinking about going CNC in the future, I'm going to need to read up on it.
I'm a much bigger fan of the whole "set to measurement" than "set by ear" thing. I do the same thing with cooking...I wanna measure out every ingredient. Drives stick lady crazy.
As difficult as it was to avoid the obvious joke, I kinda like this more. Just binged the series, rather liked it, so why not?
Still...Im having some difficulties with the transfers and etching. Alignment is difficult to get right...I always seem to get it skewed by a degree or so. My little 30 watt power supply doesn't quite have the oomph to get it done in a reasonable amount of time either.
Thinking about going CNC in the future, I'm going to need to read up on it.
