ShamWah - inductor

[toto_]

Hi guys,
I'm building the ShamWah pedal, I bought this inductor :

Eleca Halo Inductor, 15,50

Eleca Halo inductor for wahs Inductance: 600mH Height: 14mm Diameter:18mm

www.musikding.de

but the pins don't match the pcb's pads. Should I cut the 6 pins where there is no wire soldered to and solder the 2 left on the pcb? But on which pads (schematic says pads 1 and 4)?
Thanks

 

[Fontelroy]

hey did you ever figure this out? I'm about to start this build myself and am quite curious what to do

 

[toto_]

From what I remembered the pads did match the pins

 

[Fontelroy]

Based on the part I'm not entirely sure which pads are 1 and 4, you wouldn't happen to remember? does the number correspond to the pin to its right or left?

 

[fig]

Looking at the trace there, I think you just make sure the 2 pins on the transformer with wire leads to them are EAST/WEST oriented.

 

[toto_]

Not sure it'll help :

I think I found the answer by looking at the trace and the inductor doc (I should've added more details when I found the answer...)

 

[Fontelroy]

cool, i think i got it figured out tho i'm missing some components to finish the build so i won't know till the rest of my parts get here