1uF 63v Wima will fit, and 1uF MLCC also fit. 1uF 100V Wima are HUGE and definitely won't fit.
Are you using the Female 20 Pin Header from Tayda? Because that is a must, and you definitely don't want to solder in the seed directly to the terrarium
Also regarding the smaller 1u caps, it also seems like socketing the TL072 might be too risky. It looks like it is right up against the bottom side of the daisy when you socket it underneath it. I'll probably just solder the TL072 directly since I won't be swapping IC's. Is this what other folks have been doing?
I put the TL072 in a socket and have no issues putting the daisy board in. You are right that the daisy board gets very close to it and may be touching the top of the TL072, but I have been running it boxed up like that for over a month and it has been fine.
I put the TL072 in a socket and have no issues putting the daisy board in. You are right that the daisy board gets very close to it and may be touching the top of the TL072, but I have been running it boxed up like that for over a month and it has been fine.