Stuff

pcb rookie said:
if you are struggling to visualize that ... it's probably that these is no use for it with the purpose I had mind!!!! 😂
Click to expand...
I was wondering if the stencil can be as a mask to get a cleaner solder using a conventional iron and 60/40 solder when soldering let's say a FV-1 chip ... probably not what it was intended for...
 
  • Like
Reactions: fig
fig said:
🤔🤷‍♂️

I know of two ways to find out;

1. Google it and have your hopes dashed to pieces by the over-saturation of misinformation.
2. Try it and see.

I think I'll do a #2.....then try the second one. :ROFLMAO: Stay tuned!
Click to expand...
Can't wait for a report back :ROFLMAO:
 
  • Like
Reactions: fig
Fig's snipper rack? Lemme see that...
That's just some acrylic-sheet that's been bent into a triangle, more or less. That's the sort of project my junior high had us do, only it was a couple of squares of white and red that we had to melt-bend into a stupid-looking candle-holder instead of something useful like Fig's cutter/pliers holder.

If you've got access to a sheet-metal brake of any size (I recently saw some "craft" sizes that were hilariously petite), you could bend up a plier-rack in just a few bends.

Acrylic or metal, I don't care, looks like a handy item to make. My amp-sifu made himself one out of metal & wood, but inverted, so a V instead of a ^.

Sorry, rambling again, I should sleep.
 
Harry Klippton said:
Say Mr @fig, where'd you get that cutters holder that's in your first pic in this thread?
Click to expand...
Oh, that's my Small Bear upgrade! I had one made from cardboard wrapped in duct-tape. It worked fine, but they had these on sale before they closed and I made a couple larger orders for stuff I thought might be handy later on (well-played fig)...the plier rack was just impulse. :ROFLMAO:
 
You must log in or register to reply here.
Back
Top