Tayda enclosure template will not accept a 12.20 mm hole for 3PDT.

S

Stonezero

New member
Hi crew,

I was going to smash out the Kliche Boost using the Tayda Template that is included in the Build Docs from PedalPCB.

I’m using Chrome as my browser, but that should be an issue, in fact it is the preferred browser.

In fact I tried it one of the other provided templates, same story.

So I tried design a new template, added hole 1 as a 12.20 mm hole and save file.
Error- “Enter a Valid Value”

Short version:

I am getting an error message when I try to save the file. ERROR appears on hole 1 which is for the 3PDT. Size entered is 12.02.
Error message - Enter a Valid Value”

Surely this can’t just be me. First time user thou.

Assisance required as I’d like to test the Tayda UV printing and drilling to calculate time vs cost for production runs.
 

Attachments

  • FB871F6C-5305-44E9-9FEC-DA2E18F707BF.png
    FB871F6C-5305-44E9-9FEC-DA2E18F707BF.png
    1,017.8 KB · Views: 20
If they're letting you do 7.2, but not 12.2, maybe they don't have the correct size drill bit to accommodate that? I dunno. Just a wild guess.

EDIT: I just tried a 12.2mm hole using Chrome v96 on desktop and it accepted that value.
 
Last edited:
If I enter 12.2, it only shows 12, but it doesn't give me an invalid value error, I think that field is only set up to take 2 digits and a decimal
 
Make your browser port full width to see the decimal places?

I think you should be good as long as the error's gone. I'll check it on my end if you want to share your link.

noerrors.png
 
I think you might be right, was working on mobile at that stage and wanted to get a quick order in.
Wasn’t around my laptop so I’ll check in on the laptop and all should be fine if you are all successful.
Thanks for all the heads up.

STP
 
You must log in or register to reply here.
Back
Top