Basically, I'd like to add a 1/4 jack that can be used for the A/B switch.
While I did find this thread on the subject, https://forum.pedalpcb.com/threads/thermionic-deluxe-remote-channel-switching.4013/
I wanted to see if my lego-bricks / paint-by-numbers level of experience could think this through.
If someone could tell if I'm on the right track or just flat-out thinking of it wrong, it would be greatly appreciated!
- Take the Basic Relay Bypass (latching) https://www.pedalpcb.com/product/pcb394/
- But then wire it so that one pair of in/out is channel A, and the other pair of in/out is channel B
- use SPST for the footswitch
- use a switched jack, and wire it all up in some way that makes sense.
While I did find this thread on the subject, https://forum.pedalpcb.com/threads/thermionic-deluxe-remote-channel-switching.4013/
I wanted to see if my lego-bricks / paint-by-numbers level of experience could think this through.
If someone could tell if I'm on the right track or just flat-out thinking of it wrong, it would be greatly appreciated!
- Take the Basic Relay Bypass (latching) https://www.pedalpcb.com/product/pcb394/
- But then wire it so that one pair of in/out is channel A, and the other pair of in/out is channel B
- use SPST for the footswitch
- use a switched jack, and wire it all up in some way that makes sense.