Top Control KoT

[Fingolfen]

So I've lamented in my recent KoT build that I'd really like a version with all of the controls up top... Sooooo... I'm trying to lay one out... I think I've managed to get the circuit diagram correct... but now trying to lay it out I see why people haven't gone this route! *lol*

Here's the two pedals themselves... I'm handling the I/O and even a send/return loop with the 3PDT daughter boards like the Duo Phase...



... and the power section...



Anyone see anything hinky at this point????

 

[Sturdag Lagernathy]

No switchable power supply?

 

[manfesto]

I’ve also thought off-and-on about doing one of these with all top-side controls (and probably in a vertical 1590BB), to save space and make it easier to use I was gonna implement the clipping as a single switch (soft clip/no clip/hard clip) similar to the PoT/Pauper since I’m pretty sure most people don’t actually use the “both hard and soft” clipping mode.

(Probably would use a DPDT switch so that I could still use a separate pair of single diodes for the hard clipping instead of the two-in-each-direction like the PoT/Pauper though)