Unison Double / Pythagoras Tayda Drill

[Magous]

Does anyone have a Tayda drill file for the enclosure of a Unison Double Tracker / Pythagoras by any chance? Or know another board that has the same template?

 

[Nostradoomus]

experimentally yes, it should be fine though. Same as the deflector etc but a smaller slot for the toggle switch. @Robert maybe give it a once over if you can

Tayda Electronics Drill

Tayda Electronics Drill Designer for custom enclosures.

drill.taydakits.com

 

[Noodles]

This is the one I’m using for a D3lay which almost done. Of course I forgot the switch hole when I sent to Tayda .

As usual check the hole dimensions for actual component size.

Tayda Electronics Drill

Tayda Electronics Drill Designer for custom enclosures.

drill.taydakits.com

 

[Magous]

experimentally yes, it should be fine though. Same as the deflector etc but a smaller slot for the toggle switch. @Robert maybe give it a once over if you can

Tayda Electronics Drill

Tayda Electronics Drill Designer for custom enclosures.

drill.taydakits.com

Thank you soooo much

 

[Magous]

This is the one I’m using for a D3lay which almost done. Of course I forgot the switch hole when I sent to Tayda .

As usual check the hole dimensions for actual component size.

Tayda Electronics Drill

Tayda Electronics Drill Designer for custom enclosures.

drill.taydakits.com

Thank youuuu so much

 

[Magous]

Appreciate both of you. I’m so bad at measurements on enclosures.