jwyles90
Well-known member
Hey all!
I know this isn't a request for PCB help, but I've hit a wall with this one and was hoping another set of eyes (or brain) could help me figure this out. I recently finished this Mind Warp vero build, and it isn't cooperating with me. I'm getting signal when bypassed, but when I engage the pedal I'm not getting any sound of it aside from this weird like, chirping LFO type noise. It almost sounds like I can hear the LFO LFO-ing when I adjust the rate and depth knobs, but I'm not getting anything else out of it. I've replaced the chips, double-checked for any bridges, checked all my cuts to make sure they were actually cut, checked the input/output to make sure they weren't going to ground, and measured voltage at the diode, Op-amp, and regulator. I'm getting normal readings for all of it, so at this point I'm pretty stumped as to what could be causing it to not work.
Any help is much appreciated!
I know this isn't a request for PCB help, but I've hit a wall with this one and was hoping another set of eyes (or brain) could help me figure this out. I recently finished this Mind Warp vero build, and it isn't cooperating with me. I'm getting signal when bypassed, but when I engage the pedal I'm not getting any sound of it aside from this weird like, chirping LFO type noise. It almost sounds like I can hear the LFO LFO-ing when I adjust the rate and depth knobs, but I'm not getting anything else out of it. I've replaced the chips, double-checked for any bridges, checked all my cuts to make sure they were actually cut, checked the input/output to make sure they weren't going to ground, and measured voltage at the diode, Op-amp, and regulator. I'm getting normal readings for all of it, so at this point I'm pretty stumped as to what could be causing it to not work.
Any help is much appreciated!
Last edited: