Vibrabot drill template

[innerlight]

Hi all!
Has anyone got a template for the Vibrabot that they could share? Ie one I can print to DIY the drilling?
Also, I am curious about the calibration process. I see there is a trim pot, what is that adjusting and what is the procedure there? If someone could talk me through that process id be eternally grateful!

Many many thanks, super excited to have this one on my board! A desert island pedal for me.

 

[Giorfida]

Hi all!
Has anyone got a template for the Vibrabot that they could share? Ie one I can print to DIY the drilling?
Also, I am curious about the calibration process. I see there is a trim pot, what is that adjusting and what is the procedure there? If someone could talk me through that process id be eternally grateful!

Many many thanks, super excited to have this one on my board! A desert island pedal for me.

I haven’t seen one, but looking at the board pic, I’m guessing the “3 knob” layout would work (ie like the Muffin Fuzz etc)

 

[innerlight]

LEGEND!
Can someone confirm this?

 

[Robert]

Can someone confirm this?

That's the one.

Just remember to drill the center hole for a toggle switch, not a pot.

 

[innerlight]

THANKS SO MUCH!

 

[Robert]

Doc is up.

https://docs.pedalpcb.com/project/VibroBot-PedalPCB.pdf