Missing Build Docs / Schematics

[Robert]

Yep, full schematic will be in the Pro-10 doc. I'll update the two split project docs at that time as well.

 

[PangeaDestructor]

Yep, full schematic will be in the Pro-10 doc. I'll update the two split project docs at that time as well.

This is probably getting annoying for you, but any idea of an ETA for the Pro-10 Tayda drill template as well?

 

[temol]

Mofeta ...? anyone?

 

[Robert]

Mofeta ...? anyone?

https://docs.pedalpcb.com/project/Mofeta-PedalPCB.pdf

 

[szukalski]

Is there a parts list or build doc for the Aphrodite?

 

[Robert]

The diodes are marked S1V (the original SMD marking) but pretty much any standard rectifier diode should work fine if you aren't feeling brave enough to tack on an SMD component.

(1N4148, 1N914, 1N4001, etc)

 

[temol]

@PedalPCB - I'm just looking at Lowballer schematic - IC1.2 non inverting (pin 5) input goes to ground. I assume it should be connected to Vref?

 

[Robert]

I questioned that as well but that doesn't appear to be the case.

 

[giovanni]

That’s definitely unusual. It’s also unusual that there is no resistor between the negative input and the cap, maybe that has something to do with that.

 

[Robert]

This is probably getting annoying for you, but any idea of an ETA for the Pro-10 Tayda drill template as well?

This should do it.

Tayda Electronics Drill

Tayda Electronics Drill Designer for custom enclosures.

drill.taydakits.com

 

[MGB]

Hi guys,

I would like to place an order at Tayda this week-end if not early next week...

But since the build docs for these PCB's are still unavailable, anybody has the info for the following parts:
Xenolith Overdrive - Pot values (3x) + IC (1 & 2)
Mutagen Fuzz - Pot values (4x) + Q1 to Q3
Hwut Fuzz - Pot values (3x) + Q1-Q2 + Bias trimmer
Pumbaa Distortion - Pot values (4x) + IC + Q1 & Q2

I guess I should be OK for the remaining parts. We'll know when the build docs become available.

Thank you !

 

[Robert]

No formatting but here's the raw BOM.

 

[MGB]

Thanks a lot !

 

[manfesto]

Can the BoM for the Honeysuckle be made available?

 

[jwyles90]

@PedalPCB I know that these are relatively new releases, but do we have any ETA on when the Special K and Sproing build docs/schematics and drill templates will be out?

 

[Chuck D. Bones]

Can we get a schematic for the Unchained (Carl Martin Panama) please & thank you.

 

[Robert]

Can we get a schematic for the Unchained (Carl Martin Panama) please & thank you.

It's in the PDF now.

 

[Chuck D. Bones]

Not yet it isn't.

 

[Robert]

It definitely is.

 

[Chuck D. Bones]

Maybe I'm looking on the wrong webpage. I thought this was PedalPCB.

Oh, I get it, now. It's in a PDF, just not the one I can access.