Robert
Reverse Engineer
I'll get those schematics to you ASAP.
Missing Build Docs / Schematics
- Thread starter Robert
- Start date
Thank you!!
Robert
Reverse Engineer
The diagram isn't drawn up yet but it's pretty straightforward.
+/- go to the corresponding lugs of the DC jack.
IN goes to Input Jack Tip
OUT goes to Output Jack Tip
Each jack grounds to their nearest GND pad
The two 3PDT breakout boards are direct pin-for-pin connections.
See this build report for an example:
forum.pedalpcb.com
+/- go to the corresponding lugs of the DC jack.
IN goes to Input Jack Tip
OUT goes to Output Jack Tip
Each jack grounds to their nearest GND pad
The two 3PDT breakout boards are direct pin-for-pin connections.
See this build report for an example:
Fordable Boost+Drive
Very straightforward build, @Robert said it’s a little tight, and it is, so you should definitely put the 3PDTs in first, solder only one leg of each pot, and then get everything test-fit first before tightening all the nuts and soldering all the pots (which I guess technically you should do for...
forum.pedalpcb.com
Perfect! Thanks again!The diagram isn't drawn up yet but it's pretty straightforward.
+/- go to the corresponding lugs of the DC jack.
IN goes to Input Jack Tip
OUT goes to Output Jack Tip
Each jack grounds to their nearest GND pad
The two 3PDT breakout boards are direct pin-for-pin connections.
See this build report for an example:
Fordable Boost+Drive
Very straightforward build, @Robert said it’s a little tight, and it is, so you should definitely put the 3PDTs in first, solder only one leg of each pot, and then get everything test-fit first before tightening all the nuts and soldering all the pots (which I guess technically you should do for...
iamjackslackof
Well-known member
Bumping for the Dual Effects Loop Switch schematic 
Robert
Reverse Engineer
Bumping for the Dual Effects Loop Switch schematic
There actually isn't a schematic for that one, it was manually routed freehand.
It's basically the same as this wiring diagram with the addition of two LEDs and current limiting resistors.
2-in-1 Pedal Wiring - PedalPCB Wiki
DGWVI
Well-known member
Yep
Harry Klippton
Well-known member
Feel better @Robert and famSorry for the lack of responses, we're just getting over a week long illness here. Crawling my way back to reality now.
Quite a bit of shipping to catch up on, but I'll get these posted ASAP!
Phil hodson
Well-known member
Hope you get better soon.Sorry for the lack of responses, we're just getting over a week long illness here. Crawling my way back to reality now.
Quite a bit of shipping to catch up on, but I'll get these posted ASAP!
Feral Feline
Well-known member
Morbidpale
Active member
Cleric fuzz: Bottom is the rat. Middle is the muff. What the heck is the up position? Crazy cool but whaaaattt?! Also is the schematic available so I can understand the filters better?
Bottom = Rat = variable low pass filter
Middle = Muff = a low pass filter and a high pass filter combined
Top = variable high pass filter
Basically a Muff tone control is a low-pass filter and a high-pass filter combined, so in the cleric the two filters are individually hooked to the on/on/on switch. It turns them both on in the middle, then only one or the other in the other two positions (a genuinely cool trick from JPTRFX that I haven’t seen elsewhere but would love to be better informed if I’m incorrect)
I love the high pass filter on the OG pedal (go-to mode of the three), it lets you tighten the bass and/or get *super* sharp and aggressive