Recent content by mcluff

  1. mcluff

    Shika Fuzz (EQD Hizumitas)

    Not sure! Knobs are always the weak spot in my designs to be honest. But yeah, probably something small, or clear plastic? Thanks
  2. mcluff

    Shika Fuzz (EQD Hizumitas)

    I just ordered a Tayda UV print (with gloss) for a purple enclosure that would look like this (circle dots are where the drill holes go). If you're interested I could send you the PDF I uploaded. (Ignore the white outline around the artwork. I deleted that.)
  3. mcluff

    250k dual log pot

    Like a doofus, I ordered the wrong dual-ganged pot from Tayda. 500K instead of 250K. What'll this do if I install it instead? Cut my gain output?
  4. mcluff

    Pharmacist Overdrive

    Dying to get this one! But wanted to know if the parts are hard to source, especially the transistors
  5. mcluff

    Testing installation of a Spin FV-1?

    (The pre-mounted Leprechaun boards became available on the SAME day I got the chip! Just my luck.)
  6. mcluff

    Testing installation of a Spin FV-1?

    Hi all, first thread post! I installed a Spin FV-1 onto my Leprechaun board, and I think I got the surface mounting done right. Is there a good way to test it before I populate the rest of the board? I'd hate to think I fried the chip, only to populate the board, and have to start again from...
  7. mcluff

    Leprechaun

    This looks AMAZING. I'm sourcing parts at the moment. Did you have trouble finding the MLCC capacitors?
  8. mcluff

    Leprechaun

    I'm sourcing out the parts for one now. Super dumb question -- no need for programming the ICs, right?
Top