Recent content by okstateblues

  1. O

    1304 fuzz

    I placed my order Monday and still no response as of this morning. Not trying to slam them, I am just wanting to finish this pedal
  2. O

    1304 fuzz

    Is there another similar transistor I can use in the 1304 fuzz? I placed an order with smallbear and it still has not been processed after nearly a week. Is there another that works in this circuit that's actually attainable?
  3. O

    Missing Build Docs / Schematics

    Is the blues lawyer ready for posting?
  4. O

    M800 - No Volume

    Yes the wires could use some addressing. Also it seems as if your wiring connections are off based on the below diagram.
  5. O

    First PedalPCB Build: Obsidian

    https://stompboxparts.com/knobs/solid-aluminum-ka-series-small-knob/ Tayda is really good and so are these guys. Bookmark their page.
  6. O

    M800 - No Volume

    Pictures are worth 1000 words for this type of troubleshooting. Post a few front and backs for the group.
  7. O

    Mantle Fuzz - No output when engaged

    Also where did you get your parts?
  8. O

    Mantle Fuzz - No output when engaged

    Do you get power to the LED? Do you have sound in bypass? Also it looks like you used stranded wire and there is some bare wire above the eyelets. I would reheat those joints and push the wire further in to maybe address stray wires that may be touching another component. Also make sure the...
  9. O

    LM833 IC

    Anybody?
  10. O

    LM833 IC

    Just bought several parts for some upcoming builds and got a few LM833 ICs. I know this chip is a dual op amp and has been said as being comparable to the NE5532. Am I correct in believing this? Also does anyone have any experience using the LM833?
  11. O

    I seem to have collected more enclosures than I remember...

    I seem to be on the other end of the spectrum...too many builds and not enough boxes!
  12. O

    Troubleshooting Son of Ben Preamp Pedal

    I hear ya. I would start where signal dropped and continue down the that path to see if that cures your ails. If that doesn't work, we can continue troubleshooting
  13. O

    Troubleshooting Son of Ben Preamp Pedal

    I would suggest reflowing your joints. Looks like your not getting full penetration through the board for both holes on the PCB. I would reflow all your joints just to clean them up a bit. It may solve your issue. If you're new to soldering, youtube is quite helpful for tips and tricks.
  14. O

    Troubleshooting Son of Ben Preamp Pedal

    Can you take a closer photo for details on the solder joints? Also I recommend some isopropyl alcohol and a scrubbing for the back of your board to help clear any residue from soldering
Back
Top