Looking back at it with fresh eyes this morning... 1mm too far apart. That one was drilled at 22mm distance and I already adjusted my drill template to 21mm but have not tested it yet... holes could be a little smaller if I was certain about the placement.
Anyway, here it is : https://drill.taydakits.com/box-designs/new?public_key=SXBFVGhsTUpSaFh6d1MzUjN1ZDNyUT09Cg==
I've DYI'ed a similar concept for a 125B type enclosure. 18vDC 1.5A input supply, a 9vDC (LM317T) regulator trimmed to 9v and filtered, (5) 9vDC isolated outputs and (2) 18vDC inputs.
If i can fit this with Terro board, PedalPCB can surely fit it with their double sided layiouts!
Looking back at it with fresh eyes this morning... 1mm too far apart. That one was drilled at 22mm distance and I already adjusted my drill template to 21mm but have not tested it yet... holes could be a little smaller if I was certain about the placement.
Anyway, here it is : https://drill.taydakits.com/box-designs/new?public_key=SXBFVGhsTUpSaFh6d1MzUjN1ZDNyUT09Cg==
And that's fitted with the following, as suggested by M. PedalPCB himself, I may have added a washer so it's snug.
5mm Male standoff paired with a 20mm Female standoff
I've DYI'ed a similar concept for a 125B type enclosure. 18vDC 1.5A input supply, a 9vDC (LM317T) regulator trimmed to 9v and filtered, (5) 9vDC isolated outputs and (2) 18vDC inputs.
If i can fit this with Terro board, PedalPCB can surely fit it with their double sided layiouts!
Just received one drilled at a 21 mm spacing ... it's still not perfect, they are a bit too close now. Maybe a 21.5mm spacing would place them in the right spot.
Just letting you know if you did not made an order yet.