DMD-2 faceplate upgrade.

[tdukes]

Before and after. I guess it's kind of lame not to get a new enclosure. This turned out to be a little more work than I thought. I had to redrill the hole for the led and enlarge the ones for the pots. I drilled out the hole in the faceplate so I could use the led bezel.

 

[Iceman53]

Did you buy that face-plate or make it yourself?

 

[tdukes]

Its this faceplate: https://www.pedalpcb.com/product/dmd2-faceplate/

 

[Iceman53]

Its this faceplate: https://www.pedalpcb.com/product/dmd2-faceplate/

Thanks. My bad. Didn't realize there were faceplates available from pedalpcb. I guess the 'pedalpcb' on the faceplate should have been a clue.

 

[tdukes]

Too bad he only has a few. I have started screenprinting, but I would still get a faceplate for the octagon and module 8 since they have so many features.

 

[zgrav]

If you don't like the new faceplate on your original box you can also paint the box a glossy black or glossy silver No need to switch to a new box.