FV-1 Clock Module

[knobToucher]

Sorry if this is a daft question but I was just wondering how to connect the FV-1 clock module? There's three pads at the bottom that I'm not sure where I connect them? I might give it a go on the Leprechaun but my original plan was to make another 3verb and use it on that. Anyway, guidance needed!

 

[Robert]

The Leprechaun already uses the clock control circuit as part of the design, so no need to add it to that one.

The pads on the clock module are X / GND / VCC

Omit the crystal and 15pf cap
Connect X to pin 10 of the FV1 (one of the pads for the crystal connect to pin 10)
Connect GND to ground
Connect VCC to 9V

 

[knobToucher]

Ok great, thanks for your reply and the 3verb specific answer! So just connect X to either of the crystal pads? Maybe I should inspect the schematic and try to figure it out for myself. Cheers

 

[Robert]

I typically connect it to the pad that goes to Pin 10 of the FV1, but some EQD circuits connect to Pin 9... So you can probably connect it to either...