Opps I destroyed a pad.

[Veepedaldude]

I destroyed the first pad to the channel switcher on the thermonic deluxe. Where could I bodge the connection to instead.

 

[zgrav]

Check the schematic and the picture of how to hook-up the wiring in the build document. Find the pad on the channel switcher that is damaged. See what other parts it connects to. Use your digital multimeter to make sure those other parts (if there is more than one) still connect to each other, then connect the wire that was supposed to go to pad 1 to one of those other parts.

 

[Robert]

Left side of R1B. (looking at the component side of the board)

 

[Veepedaldude]

Left side of R1B. (looking at the component side of the board)

Super dooper.