T ttango New member Feb 15, 2023 #1 Lifted pad on the 4k7 resister for the LED. anyway I can bridge this? Schema. https://docs.pedalpcb.com/project/Schematic-Hydra.jpg Last edited: Feb 15, 2023
Lifted pad on the 4k7 resister for the LED. anyway I can bridge this? Schema. https://docs.pedalpcb.com/project/Schematic-Hydra.jpg
Synchrony Pedalworks Well-known member Feb 16, 2023 #2 It is difficult to determine on the picture. If you can do a zoom-less picture, it may help orient us and give specific directions. If you lifted a pad on the CLR resister, you would be able to do a jumper. Upvote 0 Downvote
It is difficult to determine on the picture. If you can do a zoom-less picture, it may help orient us and give specific directions. If you lifted a pad on the CLR resister, you would be able to do a jumper.
KR Sound Well-known member Feb 16, 2023 #3 If it's really bad, I think you should be able to jump it on the back side from D1 anode to the LED anode. Last edited: Feb 16, 2023 Upvote 0 Downvote
If it's really bad, I think you should be able to jump it on the back side from D1 anode to the LED anode.
Synchrony Pedalworks Well-known member Feb 16, 2023 #5 ttango said: Right under the Diode center View attachment 42137 Click to expand... If you have a steady hand and good solder sucker, you might be able to clean those pads and try the resistor again. Otherwise, us @KR Sound ’s advice above. The Hydra is a nice pedal. I hope you enjoy it. Upvote 0 Downvote
ttango said: Right under the Diode center View attachment 42137 Click to expand... If you have a steady hand and good solder sucker, you might be able to clean those pads and try the resistor again. Otherwise, us @KR Sound ’s advice above. The Hydra is a nice pedal. I hope you enjoy it.
T ttango New member Feb 16, 2023 #6 One other question. what voltage should I be seeing from pin 28 of the FV-1? Upvote 0 Downvote
T ttango New member Feb 16, 2023 #7 I jumped a resistor like so. not soldered yet. Look right? Still won't light up. Anode to Anode. Upvote 0 Downvote