SOLVED Sanguine with led breakout board.

[n3rfh3rd3r]

I finish my Sanquine distortion and everything works great except for the footswitch led. I used the illuminated breakout board and I left the indicator led spot open on the pcb. The led is in a shroud around the footswitch and I soldered it in to board where it lined up. Do I need to add a dummy led to the pcb? Do I need to jump it?

 

[zgrav]

I think you can put a jumper between those two points on the PCB. test if first with a wire and see if it makes your LED light up, then solder it in place if everything works OK.

 

[Robert]

I think you can put a jumper between those two points on the PCB. test if first with a wire and see if it makes your LED light up, then solder it in place if everything works OK.

Correct. You need to install a jumper in place of the onboard LED.

 

[n3rfh3rd3r]

Thanks a lot you guys