What's in the mailbox? 📬 📦

[Hal Harvey]

Patch cable makin' time!

View attachment 101192

I loooove Squareplug. I shudder when I think about how much I've invested into it haha.

 

[ragamuffin]

I loooove Squareplug. I shudder when I think about how much I've invested into it haha.

They're pretty great! I *almost* feel compelled to swap all my non-square plugs to square plugs. If only they were a little cheaper...

 

[EisengesisFX]

I loooove Squareplug. I shudder when I think about how much I've invested into it haha.

For real. On both sentiments.

 

[EisengesisFX]

After a brief Alaskan detour, my PPCB order arrived. Biggest thanks to @Robert for swapping a Parentheses in for the Obsidius board after I realized I'd fucked up my order. Absolutely adding an expression jack for the octave control on this one

 

[dan.schumaker]

New (to me) J-45 Standard came in the mail today!

 

[jwin615]

@Ginsly sent me this awesome screen printed Tshirt in return for some wares I sent a while back
Super dope.

It's the first transistor, created at Bell Labs in 47.

One of a kind/few. I dig it 1000%
Super generous! Thanks again!

 

[UtilityBeltFX]

Shout out to @giovanni for my new snips! Straight to the office to begin snipping things that require snipping. Thank you!!!

 

[mybud]

Snip ahoy…

 

[Harry Klippton]

Remote and punch in switch for my A-8

 

[jcpst]

A stash of goodies from Amir’s Noise Devices

 

[szukalski]

A package from LCSC. Look at the teeny cute cap! 4mm!

 

[Nostradoomus]

LCSC rules

 

[andare]

@Ginsly sent me this awesome screen printed Tshirt in return for some wares I sent a while back
Super dope.
View attachment 101309
It's the first transistor, created at Bell Labs in 47.
View attachment 101310
One of a kind/few. I dig it 1000%
Super generous! Thanks again!

What's the leakage on that?

 

[jessenator]

What's the leakage on that?

2 manyA

 

[Feral Feline]

That's the second time I've seen some reference to Amir's Noise Devices.

I searched them out after the first time, but all I could find was some sewshull mediochre, an empty Reverb store, and some defunct used listings at Guitarrel Centaur.


Is there a list of what's available?
Do I have to purchase/contact Amir through install-Gamma?

 

[tegendemuur]

A stereo and a mono module, all three channels giving 120W to their respective speakers (8ohms). Plus two step down converters to hook up to these units' aux power line. One will be set up as 9V, the other as 12V, and fuel the pcbs inside my amp. Each has 1500 mA to offer, so I need not to worry about not having enough! Might even set some sockets into the panel as to power the pedals inside the effect loop.

Wires for the power ins, audio ins and audio outs included with the purchase. Easy!

There were also a cables for the control section of the amps (mute, standby, voltage clip indicator, and that kind of stuff). Not so easy!

 

[PunchySunshine]

@ $175 it was just too good of deal to pass up. It's still en-route but I'm planning on using it to add eight more compressed inputs for my SSL18.

 

[Passinwind]

View attachment 101609A stereo and a mono module, all three channels giving 120W to their respective speakers (8ohms). Plus two step down converters to hook up to these units' aux power line. One will be set up as 9V, the other as 12V, and fuel the pcbs inside my amp. Each has 1500 mA to offer, so I need not to worry about not having enough! Might even set some sockets into the panel as to power the pedals inside the effect loop.

Wires for the power ins, audio ins and audio outs included with the purchase. Easy!

There were also a cables for the control section of the amps (mute, standby, voltage clip indicator, and that kind of stuff). Not so easy!

Are you using the hanger module power bus? I’ve done a bunch of ICEpower based builds and always just used the low voltage bipolar aux section, which worked great for my purposes. But IIRC some of the lower power and/or older ICE modules have a fairly modest aux out section. I’ve been thinking about throwing a 100 or 200 watter in my DIY acoustic guitar cab, maybe one of these days…

 

[jcpst]

Do I have to purchase/contact Amir through install-Gamma?

This is what I ended up doing, I didn’t find any other way to reach him.

 

[ragamuffin]

Got some parts from Mouser including some cyan LEDs and short electrolytic caps: guess the build I'm planning?