What's on the drawing board? 🎨🖌️

Working on a couple that I plan to have Tayda print for me. I've had them do several so far, but none with fine detail. Does anyone have experience having them print fine detail on the white layer? Does it track well, and what line thickness/spacing did you have? Here's the design I have concerns about:
1711039170759.png
I'm most concerned with the power polarity symbol and the embellishment around the LED. I've had a few designs where things have kind of run together when there's not enough space. I'm hoping that someone else has done some fine detail stuff with them on the white layer and had good results.

Thanks!
 
Brett said:
Working on a couple that I plan to have Tayda print for me. I've had them do several so far, but none with fine detail. Does anyone have experience having them print fine detail on the white layer? Does it track well, and what line thickness/spacing did you have? Here's the design I have concerns about:
View attachment 71174
I'm most concerned with the power polarity symbol and the embellishment around the LED. I've had a few designs where things have kind of run together when there's not enough space. I'm hoping that someone else has done some fine detail stuff with them on the white layer and had good results.

Thanks!
Click to expand...
I think it should be fine. My drill marks on dark enclosures are always 0.1mm crosshairs in the white layer. Meanwhile I’ve had design elements as close as 0.2mm away from each other and they didn’t bleed into each other at all. I’ve done the power symbol provably even smaller than that with no problem either. I would definitely recommend the double white option though bc I find the white to be a bit lackluster on a darker enclosure (Especially if this happens to be a sand black enclosure) without the double-white upcharge
 
I think I'm done with the weird suspense thing where I don't share anything I'm working on until the build report (seeing as I may not have one for a bit)

This one's going to be a MBP Splunker:
7uo3HCa.png

vectorized some paint splotches from my university years


This one is for the Fat Sandwich (effects layouts hangover cure):
v7sG7b3.png

sort of a Cram meets mayonaise kind of thing…


This one was intended for one compressor build, but I may repurpose it for a different one, we'll see:
Qy0n86W.png

Had to dig into the brain archives to remember how to rig models. Got the 3D meshes from Fallout New Vegas' assets, but I had to rig them (well, the fist anyway) in Maya, and manually move the rigid body stuff around.
n0Rw0RN.png

Fvg2Xis.png

It's janky, but it works for the render angle I was going for
 
You must log in or register to reply here.
Back
Top