What's on the workbench?
- Thread starter PedalPCB
- Start date
GizzWizzKing
Well-known member
Is it a dip switch in there? It looked like something gets plugged in....
Guardians of the analog
Well-known member
giovanni
Well-known member
Amazing!
Feral Feline
Well-known member
Where's the puke reaction when you need it?
Wow! What a find!
Lots of sub-rate mayo on a lot of things in Asia, like buns and other baked goods — it's on nearly everything. Either that or a
sticky substance something akin to peach-syrup that is completely unnecessary on croissants...
It's "NEWS"!
chongmagic
Well-known member
You should call it the Hella Duke.
Big Monk
Well-known member
Kidding, kidding....
You know I’d be honored!
giovanni
Well-known member
Paradox916
Well-known member
So what did the natas end up being?
Robert
Reverse Engineer
I still have a lot of SMD capacitors to remove and measure, but basically it is: Boost > 3-Stage Cascaded JFET Amp sim > 5 Opamp stages of EQ/tone shaping > Output buffer
The boost is not exactly like a TC Pre but I would assume achieving a similar goal.
It's far from a Tubescreamer.
Sound like the Too Hard Basket just to go CHUG.I still have a lot of SMD capacitors to remove and measure, but basically it is: Boost > 3-Stage Cascaded JFET Amp sim > 5 Opamp stages of EQ/tone shaping > Output buffer
The boost is not exactly like a TC Pre but I would assume achieving a similar goal.
It's far from a Tubescreamer.
SMD, probably a 4 layer PCB, Did you say Jfet's & 5 Op Amps!???
Not for me!
