Any chance you wired both LEDs backwards? It's an easy mistake to make. I know, because I did it on my last vero build. Killed the LED too. It's always a good idea to order spare parts, you will need them. I suggest you check these things:
- Make sure the transistors are tight in their sockets.
- Carefully inspect all solder joints under magnification.
- Verify all components are the correct value.
With INTENSITY all the way down and VOICE all the way up, you should get a pretty bright glow out of D2. Did you read this article? There's not much that can cause both LEDs to be off except installing them backwards. If you have a DVM, then set the controls per the first sentence in this post and measure the voltage at each pin of Q2. Should read something like this:
E: 4.4V (pin closest to C15)
B: 5.0V (middle pin)
C: 7.4V (pin closest to RATE pot)
I would not reuse LEDs that have been installed backwards. Reverse voltage damages them. 4 possible outcomes:
1. LED is dead, no light comes out
2. LED performance is degraded, light output is not as strong as it should be
3. LED is "walking wounded" - it works now but may fail at any time
4. LED functions according to spec, you dodged a bullet.
#4 is the least likely.