Build docs for Sproing Deluxe Reverb

[SteveScott]

I see several post about the

Sproing Deluxe Reverb, but on the website it says build documentation coming soon....​

Am I missing something? Or can some one post the build documentation?
Thanks for any help.

 

[Robert]

The completed doc hasn't been posted yet, in the meantime...

Parts list is here:

Sproing Deluxe

Sproing Deluxe Drill Template

forum.pedalpcb.com

Drill template is here:

https://docs.pedalpcb.com/project/drill/1590BB-DrillTemplate_SproingDeluxe.pdf

The wiring is fairly straightforward:

Input/Output jacks connect to the IN/OUT pads at the top of the PCB
9V / GND connect to the +/- pads at the top of the PCB
The two 3PDT breakout boards are pin-for-pin direct connections to the pads at the bottom of the PCB


The only "gotcha" on this one is the two 9mm potentiometers.

 

[SteveScott]

The completed doc hasn't been posted yet, in the meantime...

Parts list is here:

Sproing Deluxe

Sproing Deluxe Drill Template

forum.pedalpcb.com

Drill template is here:

https://docs.pedalpcb.com/project/drill/1590BB-DrillTemplate_SproingDeluxe.pdf

The wiring is fairly straightforward:

Input/Output jacks connect to the IN/OUT pads at the top of the PCB
9V / GND connect to the +/- pads at the top of the PCB
The two 3PDT breakout boards are pin-for-pin direct connections to the pads at the bottom of the PCB


The only "gotcha" on this one is the two 9mm potentiometers.

Thank you so much!

 

[Pedal_man86]

What printer settings am I supposed to use for this? I printed one out and the spacing between the pot/lug centers on the board doesn't match up with the spacing on the template...

 

[Betty Wont]

What printer settings am I supposed to use for this? I printed one out and the spacing between the pot/lug centers on the board doesn't match up with the spacing on the template...

Default. Full page. Check that it isn’t set to a previous scaled job.

 

[Daniel Jacques]

of course it doesn't work when I turn it ON ahah, anyone have the schematic to follow the path and see where I went wrong ?

 

[Jaudon]

of course it doesn't work when I turn it ON ahah, anyone have the schematic to follow the path and see where I went wrong ?

What did the issue end up being?