SYLV9ST9R
Well-known member
Here’s my second Constrictor build, as I had bought a pair of VTL5C10 vactrols and decided to build a second one to offset the cost of getting these from the US.
Kept a bit of my first design but with a fresh take, and opted to put the preamp gain on a pot instead of the internal trimmer.
Concerning the UV print, it is a tad offset (first time this happened to me, this visibly at least). I used a design with a border before, but everything was centered. I wouldn’t have noticed without the border, but it stil looks ok (I’m not as much OCD as I’d like to think ).
Edit: the font is a free font called "MADE Tommy Soft".
Also, looking at my design after the discussions below, I think I might have been subliminally influenced by the Lacoste logo. It's probably the reptiles talking...
Kept a bit of my first design but with a fresh take, and opted to put the preamp gain on a pot instead of the internal trimmer.
Concerning the UV print, it is a tad offset (first time this happened to me, this visibly at least). I used a design with a border before, but everything was centered. I wouldn’t have noticed without the border, but it stil looks ok (I’m not as much OCD as I’d like to think ).
Edit: the font is a free font called "MADE Tommy Soft".
Also, looking at my design after the discussions below, I think I might have been subliminally influenced by the Lacoste logo. It's probably the reptiles talking...
Last edited: