Drill templates for the Victory pedals?

[spilla]

Sorry if this has been asked and answered (i have looked on the forum) but have the drill templates for the Victory pedals been posted? Im looking for the Bobby, Cetus and Doxie.

Cheers!

 

[steviejr92]

Any updates on this? Especially the Doxie? Thanks in Advance!

 

[steviejr92]

So I just did some quick measurements and plugged it into Taydas Drill template.


This is not verified but feel free to use it. I will be using it myself to verify. Please note i havent done the in/out jacks or DC jack yet.
This is for the Doxie BTW but looking at the Cetus which i have id imagine it would work as they are laid out very similarly. Cant speak for the rest of the V1 line...

 

[spilla]

I can con firm the Magnetron delay drill guide also works for the kraken. Only difference is the led location. You should omit the led at the top of the enclosure. The 2nd led at the bottom is at a different location to the kraken (the kraken led is 2-3mm lower) but if you bend the led i think it might work.

 

[Robert]

I'll get a printed template posted shortly.

Just to confirm, all five of these projects (Cetus, Doxie, John, Bobby, and Cobbler) use the exact same drill template.

 

[Fuzzmax]

Good. I only need to drill the enclosure before rocking this guy!!

 

[Robert]

https://docs.pedalpcb.com/project/drill/125B_5-Knob-Type-4.pdf

 

[Fuzzmax]

nice thank you!

 

[Mentaltossflycoon]

https://docs.pedalpcb.com/project/drill/125B_5-Knob-Type-4.pdf

Your timing is incredible. I measured and drilled my cobbler enclosure like 10 hours ago. Add this to how frequently my "ppcb order shipped notifications" are followed by "wait list back in stock notifications" a few hours later and I'm convinced you're messing with me. I'll just be over here checking my house for listening devices.