EMU Drill Template

[chongmagic]

Just curious on how you did the holes in the enclosure for the slide switches?

 

[Robert]

For this one I just drilled a single oversized round hole for each slide switch assembly. I need to check the size, but I used one of the larger stepped bits.

You want the hole to be large enough that the entire slide switch assembly (switch + mini breakout board) can fit inside the hole, but not so large that it extends past the edge of the faceplate.

 

[Rpschultz13]

Anyone got the Tayda drill template for the EMU?

 

[Wizardofwoz66]

Anyone got the Tayda drill template for the EMU?

Came here looking for it and can't seem to find one haha

 

[HamishR]

Speaking as someone who has some genuine emu experience I can say that it's extremely difficult to drill one. As soon as you get close enough they either run away, steal your icecream (happened to my dad) or peck you.

 

[jcpst]

Here’s one version. It appears to be a good choice if you don’t plan to use the faceplate. Otherwise you may not have much clearance. Maybe someone else can confirm how well it works with the faceplate.

Post in thread 'EMU amp simulator'
https://forum.pedalpcb.com/threads/emu-amp-simulator.18554/post-230990

Also, I recently made a drill template based on the template in the build docs, because I plan on using the faceplate. This is currently unverified.

Tayda Electronics Drill

Tayda Electronics Drill Designer for custom enclosures.

drill.taydakits.com