Coda
Well-known member
- Build Rating
This time I’ve done a Tonebender MK 1.5, with an added Timbre control. Attached you will find my notes (with schematic and layout), photos, and a brief demo video!…
DEMO I’ve Done Another Thing! (Tonebender MK1.5)…
- Thread starter Coda
- Start date
This post contains an audio or video demo
steviejr92
Authorized Vendor
Your demo is private 
Coda
Well-known member
Your demo is private
Try again, but this time believe a little harder…
steviejr92
Authorized Vendor
Thats the gnarliest sounding fuzz i think ive heard. Bookmarked for future breadboarding.
The Sasquatch Bender 1.5
The Sasquatch Bender 1.5
Coda
Well-known member
Thanks all. It’s is indeed beastly. It has been a long time since my last dance with the El Chupacabra, my friends, but never before has a pedal such reminded me of the beast…
The demo is with the Timbre control at noon. It sets the bias on Q2 at around 5 or so. The range tops out at 6.7, and hits 3.8 on the low end. Does a lot to change the texture of the tone…
I have to mess with the input jack a bit. At a certain angle it grounds out…
The demo is with the Timbre control at noon. It sets the bias on Q2 at around 5 or so. The range tops out at 6.7, and hits 3.8 on the low end. Does a lot to change the texture of the tone…
I have to mess with the input jack a bit. At a certain angle it grounds out…
steviejr92
Authorized Vendor
To me thats a perfect range to have for a bias control.
steviejr92
Authorized Vendor
Came back this morning to watch the demo. This is definitely getting built. I want to try and add a clean blend to it, I really really think this wooly beast would benefit from one.
Coda
Well-known member
It’s got one. It’s wired off-board…on the guitar…
steviejr92
Authorized Vendor
You got me...
